question

spirou avatar image
spirou asked

Phoenix 12/250 not showing load % in the app

A minor, non crucial detail I just noticed but when I connected my Phoenix 12/250 inverter to the laptop (ve.direct-usb cable) to change some settings I noticed its not showing the load % in the "speedometer" display. The inverter works fine and everything, but the % display is just dead no matter what load I connected to it. The app and firmware are the latest version available.

Phoenix InverterVictronConnect
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

1 Answer
Daniël Boekel (Victron Energy Staff) avatar image
Daniël Boekel (Victron Energy Staff) answered ·

Hi @spirou

The 'load meter' in these products is very coarse, did you load it up to 100 or 200 watt?

1 comment
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

spirou avatar image spirou commented ·

The heaviest load at the time was likely a tungsten lamp which probably wasn't a 100W but 60. As said before, no big deal, just curious. Everything works and I didn't have a laptop wired there for anything other than changing settings.

0 Likes 0 ·