Victron MPPT Controller proper install

Question

replit

This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.

This question was closed Oct 17, 2023 at 09:53 PM by Justin Cook for the following reason: The question is answered, right answer was accepted

question

bolandd asked Dec 20, '18

Should the negative lead be attached to the 712 monitor shunt or directly to the negative battery terminal?

MPPT Controllers installation

2 |3000

Attachments: Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Answer 1 · 2018-12-20T20:53:15Z

markus answered · Dec 20, 2018 at 08:53 PM

Hi bolandd,

connect the charger to the shunt. Exactly there, where "Load And Charger" is written on the shunt.

Regards

Markus

1

2 |3000

Attachments: Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

bolandd commented · Dec 20, 2018 at 08:57 PM

Thank you!

0 ·