Hello friends.
Simple setup:
Multiplus converter with 2 inputs:
-48 V DC from battery bank
-230 V AC from grid
I'm not able to program my Multiplus for following scenario: the converter should use the 48 V input, if dc is >45 V.
If dc gets under 45 V, the converter shall use the 230 V AC input.
Problem: the Multiplus is an older version with old microprocessor. SW is 1920209.
In this version it is not possible to use the "virtual switch". Also its not possible to use the preset assistants.
I read that i have to program the MP by using the flag bit. But i did not understand it.
Can someone help me to program my MP?
Best greetings from Lübeck/ Germany!
Kevin