question

msleiman avatar image
msleiman asked

Smart LFP set points and VE.BMS

What is the correct voltage set point for allow to discharge ? The manual mentions allow to discharge configurable range is 2.6-2.8 V/cell. What is the expected SOC at 2.6 and 2.8V/cell ? What is the reset voltage at which battery reconnects the load ? Also, what is Capacity VS Temperature derating curve for these LFP batteries ? Finally how can I change these set points using VE.BMS ? Thanks.

Lithium Battery
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

1 Answer
Daniël Boekel (Victron Energy Staff) avatar image
Daniël Boekel (Victron Energy Staff) answered ·

Hi @msleiman

Below 3 volt per cell there is really not much SOC left, so best to cutoff loads at 12 volts.

2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Related Resources

Additional resources still need to be added for this topic