I have just started wiring up the load AC side (outlets) and I can't seem to figure out how to enable the MP inverter on the battery alone and want to eliminate if I have a setting or connection wrong - specifically with shore disconnected I can't seem to turn on multiplus - previously I think I could so I am wondering if I have a fault or something is locking things out. Neither physical switch and or the toggle in Cerbo no joy - neither INVERTER on nor Mains ON work.
If I am connected to shore multiplus mains turn on and AC1 output of Victon powers my distribution panel and I get output through my sockets (connected to a light bulb and heat gun all good) also if I use my AC2 which is a direct pass-through works fine also - so I know my connections post the multiplus are ok - it doesnt eliminate an issue on the inverter side - The Victron whilst connected to shore shows via Cerbo is in Passthrough mode.
Eletrodacus BMS specific info:
I am assuming this is a multiplus issue (hopefully programming) but I use Electrodacus BMS and it works fine with solar and shore power for charging. I have DC loads out powered fridge/fan etc (I have all loads {DC and Multiplus AC} ganged together through a common bridged octocoupler ) . I am using the two-wire BMS and have the jumper on MPP in place across pins 1 &2