question

nvelissa avatar image
nvelissa asked

Assistants don't work after update to VE.BUS firmware version v552.

I have two MultiPlus II 48/5000/70-50 in parallel. Until yesterday I was using assistants for ignoring AC Input 1 and for activating other devices throughthe primary relay, very successfully. After updating the firmware to v552, both units accept the assistants through VE configure, but in normal operation, they don't work (they don't do anything). I tried re-installing the firmware update, re-configuring the VE. bus parallel system and re-writing the assistants, with no luck.

MultiPlus II 48/5000/70-50

firmware update
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

3 Answers
nickdb avatar image
nickdb answered ·

Have you checked if the assistants need updating as well?

2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

nvelissa avatar image
nvelissa answered ·

Yes my assistants are up to date.

2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

nvelissa avatar image
nvelissa answered ·

I am thinking to load to the multies a previous firmware version, although I haven't done it before...


2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.