question

akouaenergies avatar image
akouaenergies asked

node-red-contrib-victron / Paramétrage NODE_RED_DBUS_ADDRESS

Bonjour,

Novice dans le monde Node-Red, je ne comprend pas où il faut indiquer l'adresse IP du VGX lorsque Node-Red est installé de manière indépendante sur un Rpi dédié.

Quelqu'un pourrait il me fournir cette information ?

Cordialement,


Hello,

Novice in the world Node-Red, I do not understand where to indicate the IP address of the VGX when Node-Red is installed independently on a dedicated Rpi.

Could someone give me this information?

Regards,


Node-RED
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

1 Answer
jaaksza avatar image
jaaksza answered ·

I am having a similar issue. After much learning I have assigned fixed ip addresses to my Cerbo GX and my RPi 4, in Node Red I see the Victron nodes but when I try and use them it says there are no services available.

I assume the problem is in the reading of the dbus info from my GX device, but no idea how to solve that problem yet. Using node red for the first time today thus I am extremely new at this.

In the Github guide there are steps laid out: https://github.com/victronenergy/node-red-contrib-victron#Installation-and-Usage

But I get stuck at step 4 as there is no /etc/dbus-1/system.conf file.

Anyone done this and can help?

Or better where do I get the firmware for my Cerbo with Node Red already implemented? Thx


1 comment
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

mvader (Victron Energy) avatar image mvader (Victron Energy) ♦♦ commented ·

Hi, instructions and download information for the images that include node-red is here:


https://www.victronenergy.com/live/venus-os:extended


@AkouaEnergies, sorry I can’t help with your question, but perhaps above is a good alternative

0 Likes 0 ·