Hi!
In a Quattro-II installation we have 16A as shore power limit, but never see usage about above 13A when assist kicks in. Typically with assist the output still stay below 16A
Any ideas?
This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Hi!
In a Quattro-II installation we have 16A as shore power limit, but never see usage about above 13A when assist kicks in. Typically with assist the output still stay below 16A
Any ideas?
When Power Assist kicks in there's a minimum amount that it can apply. Your particular Multi is listed as 1.5A. So if you're just over the 16 it will drop to 14.5A.
I think there's also a safety margin at play too with the limit itself, so if that worries you, raise it to (say) 17A.
MultiPlus Product page / Quattro Product page
MultiPlus 230V Manual / Quattro 230V Manual
MultiPlus 230V Datasheet / Quattro 230V Datasheet
VE.Bus Error codes / VE.Bus configuration guide
Pre-RMA bench test instructions.
Additional resources still need to be added for this topic
86 People are following this question.