Hi Smartsolar- Users :-)
I run a SmartSolar 75/15 together with 12W Solar Panels und a 12V (4S) Winston LiFeYPo 90Ah Battery in my Caravan.
Battery setup is kind of "90% full is enough -Setup" with 14V/13.4V/14.3V/30days balancing. HAve 1,7A Balancer boards on every cell.
Usually, i run the load output in mode "always on" when i use the caravan.
ATM, i am on holiday in Kühlungsborn at the Baltc Sea Coast, where Weather was quite bad. So i only got 130Wh loaded into the Battery the last 4 days, while i used 880 Wh for TV etc., all shown on the Victron Connect app.
Today, i noticed (from my gas warner beeping all the time when getting power, was the only device obn battery power at that time, taks 0,1A) that the load output switched off and on every few seconds. So i checked the battery voltage in the app: as far as i remember, it was at 13,2v.
That is way to early to switch off the battery power; these cells do have ca. 1200 Wh from 4,1V down to 3V/ cell.
Date shown here: https://www.faktor.de/batterien/einzelzellen/winston-lfypo4/lyp090aha-lifeypo4.html
Now, i changed the load output mode to user "defined 2" with off <12V and on >14,4v
I thought "Aways on" would mean" always on? Does anyone know if there are voltage limits in mode "always on"?
Best regards from Germany...
Frank