question

fenix avatar image
fenix asked

Trojan T-145 Batterie setting

Hello Victron Guru :-)

i have two brand new Trojan T-145 , what setting should i select in the SmartSolar 100-50?

Any help would be apreciated




MPPT Controllers
1569870350222.png (44.8 KiB)
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

2 Answers
Justin Cook avatar image
Justin Cook answered ·

@Fenix, assuming you're running them at 12v nominal, I'd go into the controller's settings and under "Battery", select "User Defined", and enter the voltages exactly as they appear above under "12V" system voltage. Ditto for any other system voltage.

2 comments
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

fenix avatar image fenix commented ·

,,,for the Equalizing what duration should it be?

0 Likes 0 ·
Justin Cook avatar image Justin Cook ♦♦ fenix commented ·

This will be specified in the user manual for your batteries. According to the fairly generic user manual for Trojans that I readily found online, 2-4 hours is recommended, but obviously this is determined by the user manual for your particular batteries.

0 Likes 0 ·
fenix avatar image
fenix answered ·

Tks for your help

2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.