This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Hello,
Can the charge disconnect be connected in parallel to two devices? The link below shows two diagrams - one where it controls a MPPT and one where it controls a Cyrix Li-ion. My question is can the connection be paralleled to both devices?
https://www.victronenergy.com/upload/documents/Datasheet-miniBMS-EN.pdf
Hi @Stevo07
Yes this can be done, make sure all negative connections are done first.
And: the charge enable output is only capable of providing 10mA, so if you experience problems, use a small relay in between to be able to provide more current (the relay coil voltage is the same as battery voltage)
