This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Hi Techs,
Who can help me a little to start my connection with Node-Red.
Installation:
- CCGX
- Victron Quattro, MPPT etc etc
- iHost (small home automation server), running Node Red
- All on 1 local Teltonika router, LAN system (via Wifi)
Node Red runs, IHost and the other home automation divices seems to connect and work
No good clue how to connect the CCGX!
Thanks Harold
HI @Harold
There's a few options. Could just read from ccgx via local modbus or mqtt service that runs on ccgx.
Or you could try integrate victron's node red nodes into your external node red setup:
(Need to setup Dbus TCP connection explained here:
node-red-contrib-victron (node) - Node-RED (nodered.org)
Thnaks Matt,
I tried the second, installed @victronenergy/node-red-contrib-victron
I can 'see' th victron client, but I cannot find out how to connect it
Thanks for your time!
Yes, I have read this, but:
Where to enter this...?
and this:
Or are there easier ways???
The first will be on the ccgx. You need to edit the value in dbus service. You can do this using commandline command they provide:
ie the dbus -y ..... etc
To execute command line command on gx you will need to ssh into gx device, which is explained here: Venus OS: Root Access [Victron Energy]
My assumption for the second is you set the environment variable on the system running node red guessing your iHost device. So you'd ssh into that system and set the environment varaible using export NODE_RED_DBUS_ADDRESS=[insert ip of gx device]
You might need to write the var every boot
If you're running node red as a service you may need to do this in your service file:
Environment="NODE_RED_DBUS_ADDRESS=192.168.1.9:78"
to /lib/systemd/system/nodred.service or whereever your node red file is stored
MQTT option may be easier, you can read the data via mqtt, just install mqtt on node red system and you'll have access to all data.
Some others were discussing this setup here, might help. In case you're running into same issues as them
External Node Red on Ubuntu connecting to CCGX - Victron Community (victronenergy.com)
Openhab / Homeassistant tend to use modbus tcp or mqtt for their integrations.
Given yours is node red based i imagine it'll be nice to have the victron nodes supported natively but if it is a massive headache then MQTT might be your next best bet.
(Let me know if you go node red route) I've never actually tried it would be good to know if it is as simple as following the above or if you end up running into quirks.
