Hello fellow Victron users,
I recently purchased a Victron Energy Blue Smart Charger IP22 12V/30A (3) rev2 and the newest model Victron Energy SmartShunt 500A/50mV to maintain and potentially repair my Odyssey Extreme Series AGM battery (model 31-PC2150). My primary goal is not just charging but also running a recondition cycle to address potential sulfation issues.
While reading a user review about this model it explained that this Victron charger allows for the input of custom charging profiles, which can be crucial for maximizing battery life and efficiency, especially for specific AGM batteries like mine. Unfortunately, I have been unable to locate any pre-configured profiles or "recipes" for my particular battery model, and the advanced settings menu is a bit daunting without clear guidelines.
Could anyone share their experiences or advice on configuring the Blue Smart Charger for this specific battery? Specifically, I am looking for the correct settings that would match the charging and recondition requirements for the Odyssey 31-PC2150. Additionally, any insights on conducting a recondition cycle using this setup would be greatly appreciated.
I've done extensive searching but haven't found the specific information needed. I'm hoping to leverage the community's expertise to ensure I don't damage this high-investment battery due to incorrect settings.
Thank you in advance for your help and guidance!
-Tp