[solved] Multiplus II 3-Phase system - problem with one Phase

Question

replit

This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.

This question was closed Apr 30 at 10:43 PM by Justin Cook for the following reason: The question is answered, right answer was accepted

question

csi asked Apr 21, '24

I have grid parallel system, so Out1 and Out2 is not used in my Multiplus II.

Suddenly, as you can see in the picture, the L3 is noch charging or inverting anymore.

Any advice what to do in this case would be really helpful! :-)

ESS

victron1.png (569.9 KiB)

2 |3000

Attachments: Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Answer 1 · 2024-04-30T17:54:44Z

csi answered · Apr 30 at 05:54 PM

Solved it, for anybody with same issue always check your DC connections, I had a slightly loose bolt on the DC link system.

2 |3000

Attachments: Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.