Charging Station NS shows error after updating to v1.28

"Internal settings changed, no support."

Only started showing this message after updating to v1.28.

Hoping the charger will still actually charge the car and I will find that out tonight but does anyone know why it shows this message and what it actually means?

Cheers

2 |3000

Attachments: Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Lucian Popescu (Victron Energy Staff) ♦♦ commented · Apr 15 at 03:49 PM

It means you have some parameters modified over mobus, parameters that are not on the main webpage of the device.

1 ·

pauldunn Lucian Popescu (Victron Energy Staff) ♦♦ commented · Apr 16 at 07:16 AM

So is this banner new in v1.28 because it was not there before updating.

I've not modified any settings outside of the web interface so not sure what other parameters could have been modified?

0 ·

Lucian Popescu (Victron Energy Staff) ♦♦ pauldunn commented · Apr 16 at 09:36 AM

Strange, can you restore the EVCS to defaults? that banner should disappear.

0 ·

pauldunn Lucian Popescu (Victron Energy Staff) ♦♦ commented · Apr 25 at 12:27 PM

Hi @Lucian Popescu (Victron Energy Staff)

I have finally got around to factory reset which has cleared that error.

However now I get a new error on the main page which is not listed in the manual:

Any ideas about this one?

Cheers

Paul

0 ·

screenshot-2024-04-25-at-132339.png (66.9 KiB)

Lucian Popescu (Victron Energy Staff) ♦♦ pauldunn commented · Apr 25 at 12:33 PM

What is the country selected initially?

0 ·

pauldunn Lucian Popescu (Victron Energy Staff) ♦♦ commented · Apr 25 at 01:07 PM

United Kingdom of Gr. Brit. and N. Ireland (GB)

0 ·

Lucian Popescu (Victron Energy Staff) ♦♦ pauldunn commented · Apr 25 at 01:36 PM

don't select GB yet, for GB a sensor is needed for intrusion detection. It will be delivered later

0 ·

pauldunn Lucian Popescu (Victron Energy Staff) ♦♦ commented · Apr 25 at 02:59 PM

I see. I'm not too bothered about the error showing so I assume there isn't any actual issues if I just leave it configured for GB?

0 ·

Lucian Popescu (Victron Energy Staff) ♦♦ pauldunn commented · Apr 25 at 07:42 PM

no, you can leave it like that

0 ·

question