Serial data from the SmartSolar MPPT

Question

replit

This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.

question

nigelivy asked Apr 5, '24

Hi Folks

Is it possible to get the load consumption added to the serial data from the SmartSolar MPPT?

Thanks,

Nigel

MPPT Controllers MPPT SmartSolar

2 |3000

Attachments: Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

112 People are following this question.

Answer 1 · 2024-04-06T01:10:05Z

Paul B answered · Apr 06 at 01:10 AM

as these are only on the small MPPT units, I would not hold my breath

2 |3000

Attachments: Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Answer 2 · 2024-04-06T06:42:09Z

kevgermany answered · Apr 06 at 06:42 AM

As far as I know, there's no current measurements on the load output, just a relay governed by battery voltage.

2 |3000

Attachments: Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.