Cerbo Gx does not display SmartShunt

Question

replit

This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.

question

slazrove asked Mar 25, '24

Cerbo GX running v3.30 firmware does not show SmartShunt HQ2249 running v4.14 firmware. The SmartShunt appears on VictronConnect.

Is this a fatal hardware issue?

cerbo gx SmartShunt

2 |3000

Attachments: Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Answer 1 · 2024-03-25T18:50:58Z

pwfarnell answered · Mar 25 at 06:50 PM

Have you connected with an official VE Direct cable or a DIY one. Try using another VE Direct port on the Cerbo GX.

Very basic point, the SmartShunt does not connect to the Cerbo by Bluetooth.

2 |3000

Attachments: Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Answer 2 · 2024-07-13T13:13:05Z

hereandthere answered · Jul 13 at 01:13 PM

Hello slazrove, did you solve the issue? I have the same problem.

The victron VE.direct cables should be 1:1 wired are they not ?

thanks

SOLVED ! Swap the two middle RX/TX wires

2 |3000

Attachments: Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.