question

peter-zmg avatar image
peter-zmg asked

Multiplus 24/3000/70 overload problem

My Multiplus 24/3000/70 switches on, but then after a few seconds flags an overload error.

I have already upgraded the firmware to 1941209 and executed the calibration program as specified by Victron. All was implemented successfully.

It happens with, or without, any load. I have not added any 'assistants' yet.

Anyone have any idea how to reset/cure this issue?

MultiPlus Quattro Inverter Chargererror
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

1 Answer
Daniël Boekel (Victron Energy Staff) avatar image
Daniël Boekel (Victron Energy Staff) answered ·

Hi @Peter-ZMG

this sounds like a defective device.

Maybe it can be repaired, if you don't know where it came from, here is more information on how to contact a distributor:

https://www.victronenergy.com/support

2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.