This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Greetings, On my CERBO GX I am using Relay 1 for generator start-stop. Relay 2 is Temperature - fan. I installed a computer style fan ~1amp and it ran for around five minutes and it stopped. I can hear the relay inside the CERBO activate, however, via handheld meter no power to the fan. Is this a signal I cooked the output diodes for relay 2? Every other aspect of the CERBO seems to be fine.
Thank you.
fan or power supply to fan defect? specs from cerbo relays are:
DC up to 30 VDC: 6 A
DC up to 70 VDC: 1 A
AC: 6 A, 125 VAC
Put a multimeter set to ohms on the relay outputs between Common and NO and then common and NC when it is deactivated and then activated to see if the relay is still functioning. A small computer fan should not have overloaded the relay if set up and powered correctly.
