Since two or three weeks I have a strange problem with the Cerbo GX (V3.30~7) or better the remote console. The remote console is working in so far as it shows and updates all data and I can go through all menues without any problems.
But If I want to change a setting or value, the new setting will not take effect. E.g. I can try to disable 'Modbus TCP' but the 'slider button' will not change, I can set the maximum inverter power to 2300W (value changes with +/- buttons) and the new value will not take effect. It will change back to the old setting.
Resetting the Cerbo will cure this for an hour or so, then the same thing happens again.
Any ideas what I con do?
BR, Jörg.
PS: same on the VRM or on a local connection via ethernet cable.