Firmware 2.32 corrected wifi loss and that was good.
Now I have the following problem for a few time and I suspect release 2.33.
I have a full "On-line" setup, where the multi is inverter only and a Skylla is charging from micro hydro OR, in summer, from generator if the solar panel+BlueSolarMPPT is not sufficient.
Before I start the generator, I switch the Skylla off until it is seen on the CCGX and the power limit can be accounted for. Then, I switch the Skylla on and everything is fine.
Now (2.33 ?) the Skylla is no longer found/seen by the CCGX when the generator starts. It's always listed as "deconnected". I have to manually reboot the CCGX for the Skylla to be listed.
If I don't reboot the CCGX, the Skylla starts at maximum current and overloads the generator.
No matter how long I wait with the Skylla powered and switched off, it never gets seen by the CCGX until rebooted.