Greetings, First off, the VM-3P75CT is wonderful. Realizing it is a new product there are a couple bugs. I am using it as a generator monitor on a single phase system. I have a MPII, Cerbo, and Touch with the VM-3P75CT. The CERBO, MPII and VM-3P75CT are wired to the CAN system. The VM-3P75CT is reflected as operational with expected data in the VRM Portal and is a recognized device while running. However, the device is not reflected on the on Remote Console or Touch screen. I was hoping the most recent CERBO firmware (v3.21) would correct this. The VM-3P75 CT has version (v1.05). Anyone know if this is a known issue, expected to be addressed at some point or is there something I should also do to get the Generator Data-Box to appear on the Touch or Remote Console? Thank you in advance.