This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
I have a motorised valve connected to relay two but i would like some feedback to know if the valve managed to fully open or close when being operated remotely. 
I have an option for a common wire then a open and close signal. I'm after some ideas what i could use with my cerbogx to get this connected up and to either display this data on the dashboard or in nodered.
Hi @Gareth3403030 the diagram looks over my head tbh but I would use two shelly switches for this and node red. (However probably also possible with a shelly custom driver).
One shelly switch activates the motorised valve via node red or some other manual switch. And another shelly switch to monitor for either the closed/open signal whatever you prefer.
In node red you activate the shelly switch1 using httpnode. You then loop/wait and keep checking shelly switch2 to see if it's input switch is activated. If not after x second interval (being the time it normally takes for valve to open) then you know it's failed.
In UK heating systems the open signal wire would be the orange but your diagram looks different to that.
