This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
My 700 shows accurate information while charging from shore power but when batteries being charged from alternator the volts jump up to 13.8 but the battery % continues to go down, amps shows negative number.
I must not have the shunt set up correctly. I currently have cable from charger and cable from engine block running to the load side of the shunt.
Any suggestions?
Are you certain that there is absolutely nothing else connected to the battery negative other than the shunt.
Engine block cable and charger cable are correct, but current is managing to bypass the shunt somehow and is not being counted.
My two house batteries are Hooked up in parallel. So I have a cable connecting the two negative posts together. I also have a cable running from the negative of my start battery to the negative of my house battery. Should that start battery negative also run to the shunt instead of to the house battery?
Thank you for your help!
I have the same issue, it use to work. I had the van in storage for 8month and since I started using the van again this problem has shown up
