This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
We're using two Quattro 10,000, and the Lynx system with a GX Touch 50.
(Lynx power in, distrubitor and shunt).
I have the batteries connected to the power in.
I have the POWER IN on the right, the shunt in the middle
And the distributor on the left where the controller and inverters are connected to.
I just read in the manual this
IS THERE ANY WAY TO SWAP INTERNALLY?
I can't Move all the cables without remaking them
If the Lynx System contains a Lynx Shunt VE.Can or Lynx Smart BMS, the batteries always have to be connected to the left side of the Lynx System and the rest of the DC system (loads and chargers) connect to the right side. This so the battery state of charge can be correctly calculated.
It might not look pretty but what about turning it upside down so that the power flows the right way through the shunt?
https://community.victronenergy.com/questions/120276/lynx-shunt-connected-in-reverse.html
You can rewire the voltage sense wires.
https://community.victronenergy.com/questions/32715/lynx-power-in-left-or-right-of-lynx-shunt.html
https://community.victronenergy.com/questions/120276/lynx-shunt-connected-in-reverse.html
I'm glad you brought it up.
