Hello,
i have set my MP2 to limit ac-in to 15A, charger enabled to 5A and made a couple of assistants to ignore ac-in but when aux1 is closed ac-in is not anymore ignored and when aux2 is closed charger is set to 60A.
So i expected this behaviour: when aux 1 is closed, all the loads are supported by the MP2 with ac-in and the battery gets charged around 200/250W, if aux2 is closed to, the battery gets charged around 3000W. But that not happens.
When aux1 is closed, ac-in kicks in, cover the loads but the battery gets charged max 70W. When aux2 is closed the ac-in power fluctuate a lot in cicles. it cover the loads, ramps up to max, stay there a second or two, then lower down to cover the load and the cycle repeats. It's not just some wrong readings. The BMS reports the same behaviour, it's a jk-bms connected via CAN
I have no idea why it's making a such thing or if it's a normal behaviour. All is updated at the newest firmware.
Can someone point me in the right direction to debug this?
Thanks.
