This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Dear Community,
Why don't my two Quattro 10kVA inverters (in parallel for 60 Hz, 120/240 VAC) appear on the VRM and or the Device List under VE.Bus? Is it likely a problem with an Ethernet cable the Cerbo GX does not like? On previous installations the Quattros always appeared.....but not this time.
Thank you for your guidance.
Jim 
Check again that you use the correct VE.Bus ports on the Cerbo, not VE.Can or Ethernet.
If you can't see it on the remote console as a device it won't appear on VRM. As already suggested, check the ports are right, failing that, replace the cable.
Thank you fellows---cables replaced and now I have the inverters!
Thank you again.....
Jim
