question

charliep avatar image
charliep asked

Fischer Panda NMEA & CCGX

Hi,

I have a Fischer Panda 5000i Neo which has the iContol/xControl interface, this has an output for VE.Can. The problem is I have already connected the VE.CAN to my NMEA2000 bus for the Tank Sensor. Connecting the iControl to the NMEA2000 bus does not seem to work, I can see it using the NMEA analysis tools, but the CCGX cannot see it.

Is there any way I can have both NMEA2000 and connect the genset?

Many thanks...
...(c)

Generator
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

1 Answer
Paul B avatar image
Paul B answered ·

I presume you are wanting gen auto-start here

the Panda also has a 2 wire connection on the rear of its control panel that you just connect straight to the CCGX relay and this will then control the Auto-start.

if thats what you are trying to achieve that is as its not mentioned in your post

1 comment
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

charliep avatar image charliep commented ·

I'm trying to get the genset data to appear in the CCGX, it should appear giving data about the genset and a pretty picture (and support autostart) but at the moment it doesn't show at all.

0 Likes 0 ·