Hi
I have a Quattro, two mppts, smart shunt and Venus OS Large all set up on a boat which has shore power most of the time, batteries are Super AGMs. My objective: fully charge the batteries using solar only and when they are full, or rather when the mppts are both on float, then start using the inverter until the battery soc gets to 56%, then switch to shorepower again until the batteries have been recharged using solar again. I have tried to achieve this using generator start stop assistant and general flag user assistant to "Use general flag to ignore AC input 2". DVCC is on. I cannot quite achieve this with these assistants, I was thinking that there should be a way using Node Red but the VE bus system control settings are very limited. I am open to suggestions, any help would be appreciated.