This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Hi
A Quatro 48/15000/200 installed by myself brand new
operated for about 30 minutes went into overload
Resetting with the switch does not work
Disconnected from the load and the feed switched off completely disconnected the battery
reconnected the battery only
Goes into overload almost emediately
I suspect a faulty unit
I have installed many of these and this will be my first failing basically out of the box
The Quatro was formated with new firmware 2625505 and resetted to factory defaults but still goes to Overload immediately once switched ON
this hapens on battery and or grid feed with NO LOAD connected to it
Hi @Willem,
Sounds like a fault to me too. The next step is to get in touch with your supplier.
