I have a 3 year old Quattro 8000 that is overloading whilst not connected to a load.
The unit went into overload alarm this morning with our night load at about 300w. The CCGX is showing that the load spiked at 5800w at the time it faulted but nothing that produces a high load was turned on.
I have disconnected the generator input and AC output and reset the unit.
It briefly had 230v on the output terminals with no fault showing but then resumed going into overload fault. When switching to On I can hear relays click and a static type sound from inside the unit. I did check the resistance between the AC output terminals and they are now showing 0 ohms between them.
It has also recently developed an issue where it would stop charging from the generator, with stable AC/ frequency being supplied, and I needed to turn it off and back on to restart the charge. No alarms have been triggered.
It is still charging no worries from solar.
I have ordered a VE bus to USB but don't have one atm.
It looks clean inside but I have not pulled any cards to delve any deeper.
Does anyone have any ideas?