This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Good Day,
I have a Cerbo GX. Connected to it is a Hubble AM2 Lithium Battery, Smart Shunt 500 and 150/50 Blue Solar Controler. The Cerbo picks up all the devices. The problem is that the DC load does not show. If I plug out the coms cable to the battery the DC load shows. Does anyone know how I can fix this? I need the battery to be connected so that the charger and battery can talk to each other.
Go to the menu screen, select system set up, then scroll down till you get to the setting "Has DC System" and enable this setting then the Cerbo will report the DC loads. The DC loads are calculated from the difference of what is measured by the solar controller and the shunt.
Hi! Did you configure the battery DIP switches according to the documentation? If not you can find it here: https://www.hubblelithium.co.za/victron
OK. You provided little information about your configuration. I don't own any hardware yet, but I know the shunt can be set to different roles. You might want to check that setting.
Thank You.
Under Settings - System settings - Battery Monitor I had to select the Smart Shunt.
Thanx
Is SmartSuite showing devices list and do you have it set as battery monitor ? (you may have select it instead just automatic as when you unplug battery bms comm lead in automatic battery monitor is selecting next battery monitor i.e. your SmartSuite ( it look as if bms comm is stopping Dc power from showing )
under battery measurements you can make them visible or not i.e. SmartSuite - battery bms on the VRM page
