question

joker-sk avatar image
joker-sk asked

Ignore ac not working via assistant?

Hello good day,

I have tried to set up the generator assistant with the general flag, to ignore ac in while the battery is charged higher than 30%.

It was ignoring it, however with the “grid lost” error, and in the morning i woke up to the battery being at 23% and i had to disable the assistant really quick before going to work.

Was something changed after the updates? I noticed a lot of settings in GX not being set up about the generator, even though in assistant it is.

Am I missing something?

Thank you

Generatorac ignore
3 comments
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Alexandra avatar image Alexandra ♦ commented ·
@joker_sk

How exactly do you have it set up? And what is monitoring SOC on the system?

0 Likes 0 ·
joker-sk avatar image joker-sk Alexandra ♦ commented ·

Hi Alexandra, it Pylontech battery so SOC is from them directly.
this is how i tried to set it up. Then in GX changed the "relay 1" as generator start/stop - without that, the generator menu was not accesible in the system.

Or is that the issue? that after sending this to MP2 i should not touch the settings in GX?

ignore-ac.jpg

EDIT 20:45
I have tested it just with the consumption in the range i can achieve and it works. trick was to not use the relay settings as generator in GX.. my bad.
Anyway, i have now reconfigure it to take the SOC into account and i have the "grid lost" error. I "suppose" its because upon restart, there is no grid as the logic to not ignore is not met... i really hope that when the low SOC is reached, it will connect and then the error should disappear?

Am i missing something here?

1 Like 1 ·
ignore-ac.jpg (58.6 KiB)
Alexandra avatar image Alexandra ♦ joker-sk commented ·
Monitor for grid faliure is set on the GX itself. So you will need to switch it off there.
0 Likes 0 ·
3 Answers
joker-sk avatar image
joker-sk answered ·

Hi, without the setting the relay in GX it is working as expected, only i have the errorr GRID LOST all the time its ignoring the grid. Its not lost, its being ignored lol...

Is there a way how to handle it?

2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

sanitka avatar image
sanitka answered ·

I had a simmilar problem. I had settings system in Cerbo AC1 input on none. When i changed to grid, error messages stoped.

2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Alex Leo avatar image
Alex Leo answered ·

If grid lost bothers you you can access the console,go to System Setup and disable "Monitor for grid failure".This way you wont have the error anymore.

2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Related Resources

Additional resources still need to be added for this topic

Additional resources still need to be added for this topic

MultiPlus Generator FAQ

GX - Generator auto start/stop

Automatic Generator start/stop

 Hybrid Generators

Virtual switch - Generator start/stop