This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Every time I charge my battery (Renogy 50ah) it bulk charges, goes into absorption mode then into storage.
My issue is that all I want to do is charge the battery up to it's maximum amount then disconnect it. I do not want it to go into storage mode and reduce the amount of energy it is storing.
Is there a setting i can change to stop this from happening?
@matmah dont panic!
Storage voltage for Li batteries is the same as float voltage!! 13.5v.
Perfectly safe voltage for Li batteries being held at near full state of charge. (probably 98% after a little voltage drop from the bulk/absorption voltage of 14.2v)
You have programmed your IP65 to charge Li batteries?????
