This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
I recently installed a Multiplus II 2X120 and am unable to attach the temperature sensor to the device. Maybe I'm stupid, but I can't figure out how the green connection bus works. I push the wire ends into the correct hole, but doesn't stay inserted, is there a spring release I'm not seeing?
@GaryB those terminal blocks unplug from the multi. Are there screw terminals on the right hand face?
Thanks to you both. The answer is the connection block does pull out. The wires go into the square holes and there are set screws on the side in the round holes. Problem solved.
I did not try to unplug as they appeared to by connected. Attached is a picture of the connection block I am talking about. it is labeled "N".Appendix A.jpg
I think you push into the square opening above the larger circular one. Use a small screw driver or whatever that can clear the square opening.
Once pushed in, you can insert a wire into the circular opening.
