This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
i would like to connect a relay from the cerbo gx to an aux in from the multiplus II. the relay on the cerbo gx switches depending on a temperature sensor. the aux in from the multiplus II should then switch the ac-out-2 on or off depending on the state of the aux in.
how exactly do i make the connection (cerbo: NO, COM, NC - multiplus: PLUS MINUS)?
THANKS
Hello!
I figured out how to do this TODAY XD.
1. Get a wire, hook up MOD, and CO on Cerbo relay 2 slot.
2. Hook up wire to Multi Aux 1 MOD wire to pos, and CO to Neg.
3. Create AC-Out2 relay assistant one to trigger on Aux 1 open and a second AC-Out2 relay assistant for Aux 1 close (someone let me know if second rule is redundant :P I just did it just in case), upload to multi
4. Bob is your uncle! :P
I am using this to switch my geyser on and off.
thank you so much!
the solution is also in this post, moreover with photo to find... since in french, I have not found this immediately.
https://community.victronenergy.com/questions/211848/relais-ac-out2-pilote-par-relais-cerbo.html
