Hello,
Following the last update about the internal Temp sensor of my smart lithium battery:
VictronConnect now with Smart Lithium battery update
Before I found this forum, I asked a question here: http://disq.us/p/1xqfygg:
Hello Great news, very useful, I asked this feature here: http://disq.us/p/1nuh76g
The solution was not easy: http://disq.us/p/1nxidzh
And applauded that here: http://disq.us/p/1r8q3ka and http://disq.us/p/1r5sdy7
Big thanks !
BUT BUT BUT ....
My Victron 100A Lithium battery has a temp sensor that has a big offset...
That means that now the internal battery probe says that the temp is 1°C and 4° ... yes, one measurement says 1° then some seconds later 4° then back to 1° etc...
Two outside thermometers, placed close to the battery measure a temp that is around 7.5°, so the offset is 6,5° (or 3,5°)
That means that I have to wait until it's 5°+6,5°=11,5° to be able to start to charge my battery...
That's a BIG problem for me... as i'm sometimes traveling in "cold" countries where the average temp is more between 6 and 10°...
Do you have a solution for this ?
I do not want to void my warranty by setting a lower T° in the app...
After some research I found someone else having the same problem: http://disq.us/p/1wwop76
My Smart Lithium 100A is connected to a BMS 12/200 and charged with an car alternator and/or a MPPT 75/15. they are connected to the AB port
Thanks !