Hi.
I have two SmartSolar MPPT charging a bank of batteries. A Phoenix 24V 1200VA inverter is then used to provide the AC. I'm running Venus OS on a BeagleBone Enhanced and this all works fine. I can see the solar yield from both MPPT and how much AC power is being consumed via the Phoenix.
But I've now purchased a MultiPlus II 24V 3000VA and, so far, am only using it as an inverter. It is connected to the BeagleBone via CAN.Bus and is detected fine (so in "Devices" I see both MPPT, the Phoenix and the MultiPlus II) but when the MultiPlus is turned on, the "AC loads" in the summary screen only shows the load on the MultiPlus. If I turn the MultiPlus off, then "AC loads" shows the Phoenix load again.
I know that Venus OS can see everything because in the menus, it shows me the current loads for both inverters.
So, to summarise, "AC loads" either shows the MultiPlus load OR the Phoenix load, but not both.
Ideas?