Hi all, my phoenix 12/375 inverter does not show any load information on the dial. What could be wrong?
This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Hi all, my phoenix 12/375 inverter does not show any load information on the dial. What could be wrong?
Hi everyone, I'm experiencing the same issue. Have a 24/375, applied a 50W and nothing appears.
I have read the serial output but the load is reported as zero. Firmware version is 1.21.
Is the unit defective?
With regards
Niccolo Gallarati
I have this same issue. I purchased the VE Direct to BT Smart Dongle for one reason alone: to show the load (Watts) on the inverter, as I cannot see this on my Cerbo (as the Phoenix 375W inverter is not connected to it - too far away to be practical to connect). Load meter does show some bars, but the % indicator remains at 0% and the full scale is 200 ... why is there not a simple reading like (for example) "Load: 62W" ? is there anything one can do to improve on this? I'm running the latest software both on the Dongle and on the Inverter.
Additional resources still need to be added for this topic
11 People are following this question.