question

adeart avatar image
adeart asked

MULTIPLUS 24|5000|120-100 IN FAULT STATE AFTER FIRMWARE UPDATE

11029f8e-16c1-44cf-8349-ab50e038227d.pngI am still in a dilemma on what to do, after a firmware update from v159 to v502, my MULTIPLUS is a permanent fault state with the message “Overload L1 Ve Bus System”. I still need your help guys. Should I roll back to previous firmware v159?

VE.Bus
11029f8e-16c1-44cf-8349-ab50e038227d.png (236.7 KiB)
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

2 Answers
nickdb avatar image
nickdb answered ·

If you drop the AC feed does it resolve after a reset, ie just run it off battery.

1 comment
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

adeart avatar image adeart commented ·
Did not try that but will try it and see. thanks for the tip
0 Likes 0 ·
derrick thomas avatar image
derrick thomas answered ·

Did you run veconfig and restore settings on the multi? Firmware update always wipes out settings

1 comment
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

adeart avatar image adeart commented ·
Yes, i did restore settings after the firmware update
0 Likes 0 ·

Related Resources

What is VE.Bus?