Hi
Is the SmartSolar MPPT 100/30 able to deal with a LiFePo 24V/200Ah battery pack ?
Battery Pack has integrated BMS 8S 200A (also RS485/CAN)
Plan to connect 2 x 395Wp (44.7V) PV panels in series connection.
appreciate feedback
best regards,
This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Hi
Is the SmartSolar MPPT 100/30 able to deal with a LiFePo 24V/200Ah battery pack ?
Battery Pack has integrated BMS 8S 200A (also RS485/CAN)
Plan to connect 2 x 395Wp (44.7V) PV panels in series connection.
appreciate feedback
best regards,
By deal with i assume you mean charge?
At 90% DOD charging at 30A will take close to 7 hours. So if you are planning on that kind of use, get more solar.
The series connect, check your max VOC at min temps with the online calculator and other details for your panels.
Hi Alexandra
yes, question was regarding charge of LiFePo batteries. For the setup mentioned above, i need more panels, agree ;-)
With exactly that panels i was able to catch 3.6kWh today, which is to less for 24v/200Ah.
Also noticed that SmartSolar MPPT 100/30 does not have a "Load" output compared to MPPT 100/20.
Is there an alternative way of connecting and switching a Relay to MPPT 100/30 ?
According to the MPPT Calculator I'm fine with 2 panels in series connection up to 375Wp/Panel.
For higher Output panels it recommends MPPT 100/30.
Additional resources still need to be added for this topic
Additional resources still need to be added for this topic
Did You Know - How to create a battery profile for non-Victron batteries?
49 People are following this question.