question

h2009 avatar image
h2009 asked

Need help with Overload script - can't get it to work correctly.

Hello.

I'm trying to get over Overload alarms and warning I'm getting when my 3 Phase MP2 10kva units get around 8kwh load (see below)

screenshot-2023-03-19-at-213729.png

screenshot-2023-03-19-at-220343.png

screenshot-2023-03-19-at-220418.png

So I've got a script that is running to isolate the mains power during the peak hours of my tariff, and then turn on and charge the batteries off peak (12am to 5:30am). I've got 80kwh batteries and plenty of output power from them available.

screenshot-2023-03-19-at-214219.png


Then I've tried changing this script above to the following, but for some reason when the overload warning or alarm starts there is no change to the MP2's switch; or if it does switch, then after it clears it will not check the basic time script; or it will rapidly switch between all switch states in the script.

Can anyone help me - happy to pay to get this fully fixed and resolved.


screenshot-2023-03-19-at-213805.png

screenshot-2023-03-19-at-213756.png

screenshot-2023-03-19-at-213745.png

ESSNode-REDalarmwarnings
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

0 Answers