This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
I have installed x5 GSO li-ion 200ah 48v to Quattro 48/10000 via lynx 1000 with Cerbo.
It works as it should but I’m trying to get a pin out schematic between the batteries and Cerbo. I struggle in this area and any help is appreciated. Included is a pic of the batteries can pins. Thanks.
Good day. I have the exact same batteries from GSO (a total of five batteries of 200 ah each) mounted in parallel however I’m facing a major issue with their BMS. Every two to three days I have to reset the BMS (by turning them off and then on). The issue I face is that my inverters end up seeing one battery instead of all five as a result reducing the charge and discharge amperage. On the inverter I see the error 0x1000. I have recalled the whole thing to make sure that the batteries are balanced but this did not help.
Are you facing the same issue?
