Hi,
Hoping someone might be able to advice. I have already looked through the previous posts on the forum and haven't managed to make it work yet.
I have a Victron Multiplus ii GX and 3 pylontech us5000 batteries, these were installed for me but i have been left to do the setup.
I have updated the firmware and am running v2.93. I downloaded the veconfig file and used ve configure 3 to update it adding the ESS assistant and setting this up and then sent this back to the multiplus. As far as i can see all settings are correct. The ve config file is showing ess assistant (i redownloaded it to check) but it does not appear in the remote console.
Any help much appreciated.
Alistair