question

der-ambergauer avatar image
der-ambergauer asked

Node Red: Relais on Smart Solar

Hello,

I would like to control a heating rod in Node Red. To do this, I would need to use the relays from two Smart Solar. Everything should actually fit in my Flow, but I can't switch the relays. Do I have to make a presetting in the devices themselves, as I have to do with the Cerbo (setting: Manual)?
Or is it because the Smart Solar are currently "Off" due to the lack of solar input?
Or what could be the reason that the relays do not switch?

Greetings from the Ambergauer

Translated with www.DeepL.com/Translator (free version)

Node-REDRelaysmart solar set-up help
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

3 Answers
metz-producties avatar image
metz-producties answered ·

I have the same situation here.

2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

matt1309 avatar image
matt1309 answered ·

Hi @Der Ambergauer @Metz Producties


I use shelly smart switches to achieve this. Use http node to activate the smart switch. Relatively affordable and then dont have to be place close to solar as long as they're in wifi range/on same lan

3 comments
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

metz-producties avatar image metz-producties commented ·
Thanx! I wil try Shelly
0 Likes 0 ·
metz-producties avatar image metz-producties commented ·

How can I import or see the Shelly pro in the victron system?

0 Likes 0 ·
matt1309 avatar image matt1309 metz-producties commented ·

Hi @Metz Producties

There's a load of ways depending on what you need it for.

Personally I just use it for turning things on and off. I dont really care about recording data in victron system (I use openhab for that). so i just use NodeReds http node to send on/off command.


If you want to monitor the load being used i think there's a custom driver you can install for that:
https://github.com/victronenergy/dbus-shelly/




0 Likes 0 ·
Dirk-Jan Faber (Victron Energy) avatar image
Dirk-Jan Faber (Victron Energy) answered ·

You can use this node: https://flows.nodered.org/node/node-red-contrib-relaycontrol Which offers support for several (network connected) relay control boards.

2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.