question

safari-oz avatar image
safari-oz asked

I can’t see my solar controller in VictronConnect anymore

I had to restart my victron system after my batteries failed. It’s all back up and working properly but I can no longer see my Smartsolar charge controller (MPPT 100|50) in the Victron Connect Device List. I can see it via my Cerbo GX and it’s charging (when the sun is out :-). Also pressed the orange refresh button, bottom right. Any advice on why it’s not being detected in the Victron Connect Device List please?

1674446401062.jpeg

1674446401123.jpeg

1674446401169.png

MPPT ControllersVictronConnect
1674446401062.jpeg (102.9 KiB)
1674446401123.jpeg (99.9 KiB)
1674446401169.png (215.0 KiB)
2 comments
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

klim8skeptic avatar image klim8skeptic ♦ commented ·
The bluetooth might think that it is connected to another device, and need a reboot.

Turn pv breakers off, then turn the batt breaker off for 30 seconds.

Turn batt back on, then the pv breakers.

Fingers crossed the bluetooth is now accessible.


2 Likes 2 ·
miczakatak avatar image miczakatak klim8skeptic ♦ commented ·
This solution worked for mesas I was having the very same problem and walked through these steps and I am back up and running!!
0 Likes 0 ·
1 Answer
safari-oz avatar image
safari-oz answered ·

OK so it took a while for me to get back round to this but in the end I disconnected the controller from the battery by removing a midi fuse, reconnected and it came back up on Victron Connect via Bluetooth again…. So basically switched it off and on again and it started working again :-)

2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.