Hi community
I've the following setup:
- Octo GX (running Venus OS large)
- Node RED installed
- installed package "node-red-contrib-tuya-smart-device"
- Tuya Zigbee gateway (Silvercrest from LIDL)
- 5 Tuya power sockets connected to the Zigbee gateway (Silvercrest from LIDL)
- Tuya account for getting device ID and device key
so far so good.
when I place the tuya node just like this without any connections,
put inside a non existing ID and key and deploy it. Nothing happens as expected. Node RED is still running and behaving well.
But as soon as I just put an existing ID and key of one of my existing power sockets and deploy, Node RED will immediately stop working. When I try to access it, I get a message something like "This device is probalby not running Node RED".
In order to get it back working, I have to enable Node RED in safe mode, remove the ID and key and restart Node RED in normal mode again.
If anybody here has tried Tuya with GX then please share your expirience. Thank you!
Best regards,
Matthias
