question

etedverhard avatar image
etedverhard asked

Multiplus II GX AUX-port

I want to use the AUX of my MPII-GX for indicating the primary powerloss.
Unfortunately I can't find the right items to configure it.

Problem is: My house is fully connected to my 3 MPII, so we don't notice a powerloss of our supplier.

I want to indicate the happening with some LED's so I can adapt my energy consumption.
Also in case of emergency-power of the MP's, the wallbox for the vehicle should switch of.
Unfortunately I don't have the Victron Wallbox

Can you give me a hint, how to configure this?


Thank you

aux
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

2 Answers
Jason - UK avatar image
Jason - UK answered ·

@ETEDVERHARD Most people put non-critical loads on the AC-out2 of the Multiplus unit so in the event of a power cut, the AC-Out2 disconnects in the event of a grid failure. If you want to activate a led, you can set up an assistant to activate one of the relays in the event of a grid failure.

1670600405098.png


1670600405098.png (133.4 KiB)
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

etedverhard avatar image
etedverhard answered ·

That was what I was searching for.
Thank you very much.

2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Related Resources

Additional resources still need to be added for this topic