question

arona avatar image
arona asked

Connecting multiple MPPT controllers to Smart BMS 12/200

I am looking to connect two Victron Smart MPPT controllers to a Smart BMS 12/200. The Smart BMS 12/200 only has one port for the VE Direct Remote On/off wire. Is it ok to just splice another wire to the same port?

BMS
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

1 Answer
klim8skeptic avatar image
klim8skeptic answered ·

It is best that you read the Smart BMS 12/200 manual esp the 5.1. Appendix A.

For Victron mppt that have remote ports, no special cables needed.

For Victron mppt that only have VE Direct ports, VE.Direct non-inverting remote on-off cable is needed (article number ASS030550320): is required for each mppt.

It is OK to wire 2 ASS03550320 to the charge disconnect port.

Good luck.


2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.