This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Hi,
With the isolators connected as drawn, I'm getting 8.4V on the input of each isolator with the engines off. I have disconnected the input of both isolators and measured voltage on both B+ cables coming from the alternators and they are basically 0V. The grounds from MNB to isolator are #14. With only the B+ input cables off, I measure 8.4V on the input stud. Is there anything I need to check? Any ideas?
Thanks!
Is this related to Victron equipment?
Yes, the isolators are Argofet 100-3's
Additionally, If a ground is not connected, the input has around 24.6V
A disconnected ground does not affect the other isolator's voltage on the input.
I'm thinking the Argofet is supplying a small voltage back to the alternator, so that the alternator knows there is a load connected and to supply charge when the engine is started.
Some alternator regulators will not supply charge without a battery connected. Some just damage the alternator regulator if there is no load on the output.
Thanks for the idea.
I'm going to measure current to ensure the isolators are doing their job.
